|
Who's Online
There currently are 5959 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very good conversation, Pretty fast Service, wood do it again,
Have paid by Paypal, so i got the Service Manual online after 15 Min.
Very helpfully.
Greeting from Germany,
Hans
;
Good-quality scans. Detailed description. I hope I can repair the machine.
;
High-quality scanning. Detailed description. Recommend for all technician. A+++
;
This is a good quality scan of the original Service Manual from Nordmende, Germany. Contains the circuit diagram, PCB layout, adjust/tune instructions as well. It is NOT in English but in GERMAN language! That was quite right for my german friend from the lower east side in Berlin.
;
Received via e-mail this PDF manual is worth the money. This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand. I have later seen the original manual and it was printed in colour, but this particular manual is black & white but scan resolution is high end quality! All drawings and pictures are presented in great detail. So, nearly perfect score in my opinion.
If you own the turntable you also should own the manual!
928 Mixing Console
APPLIES TO VERSION 2:
Each input unit is equipped with two remote control relays. The normally-open contacts of these relays are terminated on the 9-pin D-type connector of the rear panel. The relay contacts can be used for remote control or signalization. The function and the behavior of the remote control can be varied with jumpers J3, J4, J5, and J11.
J3 1-2 Start pulse on the REM output of the remote control. Stop pulse on the STOP output of the remote control. Latching contact on the REM output of the remote control for as long as the fader is open and the ON key is active. Stop pulse on the STOP output of the remote control.
Remote control output
2-3 (default)
Remote control key
With the START key the fader start can be prepared or initiated. If the key is pressed when the fader is closed (dim backlight of the key) the fader start command is executed as soon as the fader is opened and the ON key is activated. If the START key is pressed when the fader is already open and the ON key is active, it immediately executes the fader start command.
J4 J11 J4 J11 1-2 (default) closed 2-3 open 1-2 2-3 (default) START key is active START key is disabled, fader start depends only on the fader and the ON key START key generates start pulses START key functions as a latching start/stop key and enables or disables fader start activation with the fader control
(( J9.TBL ))
J5
Signalization
The 928 mixing console features two signaling buses that are used for on-air signaling and deactivation of the studio speakers.
J12 1-2 2-3 (default) When the microphone channel is opened, the CR monitor is dimmed (DJ mode) When the microphone channel is opened, the studio speaker is switched off, and the studio on-air lamp is activated if the ON AIR signal is available or the STUDIO ON key in the signaling unit is pressed. Microphone input acts on the signaling buses. LINE input acts on the signaling buses
(( J10.TBL ))
J13 1-2 (default) 2-3
Edition: 07.02.01
Jumpers E 3/3
|
|
|
> |
|